GALLUNOPTIMAL desoldering wick made of 2mm wide copper wire, 1.5 m long, white,
solder suction braid in a practical hand spool and thus protecting the hands from the desoldering braid getting too hot.
Our desoldering braid is made of high-quality electrolytic copper, which conducts heat very well, is braided into a braid in thin wires and soaked in flux to achieve a good absorption and suction effect of the liquid solder. The flux used for this has been developed on a no-clean basis, so it does not necessarily have to be cleaned off after application for conventional assemblies.
It is always important to ensure that the soldering tip is sufficiently die-coated to transport enough heat into the desoldering wick, at least the width of the wick should be used. As an additional aid for varying surfaces, flux gel can be used as a heat transfer medium. Protect the assembly, the conductor tracks and the components from excessive heat input and thus damage.
