Universal Hot-Dip Galvanised Mast Clamp for Tubes Ø 42–60 mm – Wall or Rafter Mounting
The AS46301 is a universal steel pipe and mast clamp designed to secure suitable mast tubes and round-tube outriggers with outside diameters from Ø 42 to 60 mm.
It can be used for satellite, antenna and technical mast installations where a suitable round tube must be fixed to a structurally sound wall, roof rafter or comparable supporting structure.
According to the available product data, the clamp is manufactured from steel with a hot-dip galvanised surface.
The fixing-hole centre spacing on the mounting side is approximately 140 mm, while the mounting holes have an approximate diameter of 10 mm.
For tubes Ø 42–60 mm
The clamp is suitable for mast tubes and round-tube outriggers with diameters from:
Ø 42 mm
to Ø 60 mm
The actual tube diameter should be checked before installation.
Wall mounting
The AS46301 may be fixed to a suitable load-bearing wall.
The actual screws, plugs or anchors must be selected according to:
wall material
tube length
antenna weight
wind area
mounting height
Roof rafter mounting
The clamp may also be used on a structurally suitable roof rafter.
The timber must be capable of carrying the mechanical loads transmitted by the mast and attached equipment.
Hot-dip galvanised steel
The clamp is manufactured from hot-dip galvanised steel.
The coating supports corrosion protection for typical permanent outdoor installations.
Approx. 140 mm mounting-hole centre spacing
The mounting-hole centre distance is approximately:
140 mm
This is particularly useful when replacing an existing clamp or comparing an existing drilling pattern.
Approx. Ø 10 mm mounting holes
The mounting-hole diameter is approximately:
10 mm
This dimension does not determine a universal screw or anchor type.
Fixings must be selected according to the actual substrate.
Suitable for mast tubes and outriggers
Typical applications include:
satellite antenna masts
antenna support tubes
round-tube outriggers
DVB-T/T2 antenna installations
DAB/DAB+ systems
FM antennas
suitable radio antenna structures
Technical mast applications
Depending on the complete mechanical design, the clamp may also be used for suitable lightweight technical mast applications such as camera, sensor or radio equipment.
No confirmed maximum antenna size
No maximum antenna or satellite dish size is specified.
Suitability depends on the complete installation, including:
mast wall thickness
unsupported mast length
outrigger length
antenna weight
wind area
structural support
fixing system
Lever forces must be considered
Long mast sections and extended outriggers create additional leverage at the fixing point.
The mounting surface and fixing hardware must be selected accordingly.
Insulated façades
Special mounting solutions may be required for external thermal insulation systems.
Loads must be transferred into a suitable structural substrate rather than being carried by the insulation layer alone.
Technical specifications
Article reference: AS46301
Article number: 46301
EAN: 4050822463015
Product type: Universal mast / pipe clamp
Material: Steel
Surface: Hot-dip galvanised
Suitable tube diameter: Ø 42–60 mm
Installation: Suitable wall or roof rafter
Mounting-hole centre spacing: Approx. 140 mm
Mounting-hole diameter: Approx. 10 mm
Maximum load: Not specified
Maximum antenna size: Not specified
Package contents
1 × AS46301 universal mast/pipe clamp for tubes Ø 42–60 mm
Clamping and mounting components according to product configuration
Mast tube, outrigger, satellite dish, other antennas and substrate-specific screws, plugs or anchors are not included unless separately specified.
