Adjustable Steel Satellite Floor Stand – 1 m Mast Ø 60 × 2 mm, Triple-Braced and Dismantlable
The AS32120 is a dismantlable steel antenna floor stand designed for suitable satellite installations on structurally suitable terraces, balconies and other stable mounting surfaces.
According to the available product data, the mast is 1000 mm high and measures Ø 60 mm with a 2.0 mm wall thickness.
The structure uses three support braces and three angle profiles with elongated holes. The mast can be levelled to compensate for minor surface irregularities and to achieve a more vertical mast position.
The steel construction is hot-dip galvanised according to EN ISO 1461.
According to the available product data, the AS32120 is suitable for satellite dishes up to Ø 120 cm.
1 m mast
Mast specifications:
Height: 1000 mm
Outside diameter: Ø 60 mm
Wall thickness: 2.0 mm
The antenna clamp must be compatible with a Ø 60 mm tube.
Check clamp compatibility
Ø 60 mm is larger than the mast diameter used by many smaller satellite dishes.
The antenna clamp range should therefore be checked before installation.
Levellable mast
According to the product information, the mast can be levelled.
This can help compensate for minor irregularities in the installation surface.
Why vertical alignment matters
A mast positioned as vertically as possible simplifies subsequent satellite dish alignment.
Triple-brace design
The mast is supported by three braces.
These help transfer lateral and bending loads into the lower supporting structure.
Three angle profiles with elongated holes
The lower structure incorporates:
3 angle profiles
elongated mounting slots according to product data
These support adjustment and installation.
Limited compensation only
The levelling capability is intended for minor surface deviations.
The stand should not be installed on severely sloping, unstable or unsuitable surfaces.
Suitable for satellite dishes up to Ø 120 cm
According to the product data, the AS32120 is intended for suitable satellite dishes up to 120 cm in diameter.
This does not represent universal structural approval for every location.
Actual suitability depends on:
antenna weight
antenna wind area
installation height
supporting surface
securing method
local wind conditions
Secure installation is essential
The term “free-standing” should not be interpreted as approval for unsecured installation under all conditions.
The complete system must be installed or secured appropriately for the actual antenna and wind exposure.
Hot-dip galvanised steel
The steel structure is hot-dip galvanised according to EN ISO 1461.
This supports corrosion protection for permanent outdoor applications.
Dismantlable construction
The stand can be dismantled, simplifying:
transport
storage
relocation
seasonal use
Typical applications
The AS32120 can be used for suitable:
satellite installations
terrace installations
mechanically suitable balcony installations
DVB-T/T2 antennas
DAB/DAB+ antennas
FM antennas
radio antennas
Technical specifications
Article reference: AS32120
Article number: 32120
EAN: 4050822321209
Product type: Adjustable steel antenna floor stand
Material: Steel
Surface: Hot-dip galvanised according to EN ISO 1461
Height: 1000 mm
Mast tube: Ø 60 × 2.0 mm
Mast alignment: Levellable according to product data
Bracing: Triple-braced
Lower structure: 3 angle profiles with elongated holes
Suitable satellite dish size: Up to Ø 120 cm according to product data
Design: Dismantlable
Package contents
1 × AS32120 steel antenna stand
1 × Ø 60 × 2.0 mm mast, 1000 mm high
Braces and angle profiles according to product configuration
Assembly hardware according to product configuration
Satellite dish, LNB, any required floor anchors, coaxial cable and additional installation accessories are not included unless separately specified.

