4-Hole Steel Mast Clamp for Tubes Ø 48–50 mm – Galvanically Zinc Plated
The AS46050 is a robust four-hole mast clamp designed to secure antenna and round mast tubes with an outside diameter between Ø 48 and 50 mm to a suitable structural support.
Typical applications include mounting an antenna mast to a roof rafter, timber beam or another suitable load-bearing structure.
According to the available product data, the clamp is manufactured from 3 mm steel sheet and has a galvanically zinc-plated surface.
Two screws are included according to the available product information. Their exact dimensions and suitability for a particular substrate are not confirmed and should therefore be checked before installation.
For tubes Ø 48–50 mm
The clamp is intended for mast tubes with outside diameters between:
Ø 48 mm
Ø 50 mm
The actual tube diameter should be checked before installation.
Four-hole mounting design
The four-hole design allows the clamp to be fixed at several points to a suitable support structure.
Possible mounting locations include suitable:
roof rafters
timber beams
structural supports
3 mm steel sheet
The clamp is manufactured from:
3 mm steel sheet
according to the available product data.
Galvanically zinc plated
The steel surface is galvanically zinc plated to support corrosion protection in typical antenna mounting environments.
No confirmed zinc coating thickness is stated.
Roof rafter applications
One typical use is securing a Ø 48–50 mm antenna mast to a structurally sound roof rafter.
The roof structure must be capable of carrying the antenna and wind loads transferred through the mast.
Not a complete mast system
The AS46050 is a single mechanical mounting component.
Depending on mast length and antenna load, additional clamps or support points may be required.
Satellite antenna applications
The clamp may form part of a suitable satellite mast installation.
No confirmed maximum satellite dish size is specified.
Suitability depends on the complete system, including:
mast wall thickness
unsupported mast length
antenna weight
wind area
support spacing
structural support
Other antenna applications
The clamp may also be used in suitable installations for:
DVB-T/T2 antennas
DAB/DAB+ antennas
FM antennas
suitable radio antennas
Replacement and retrofit work
The AS46050 can be used when replacing a damaged existing mast clamp or adding another suitable fixing point to an existing mast structure.
Included screws
According to the available product data, two screws are included.
Their use must be checked against the actual mounting surface. Additional or different fixing hardware may be required depending on the installation.
Technical specifications
Article reference: AS46050
Article number: 46050
EAN: 4050822460502
Product type: 4-hole mast clamp / pipe clamp
Suitable tube diameter: Ø 48–50 mm
Material: Steel sheet
Material thickness: 3 mm
Surface: Galvanically zinc plated
Mounting design: 4-hole
Included screws: 2 according to product data
Maximum load: Not specified
Maximum antenna size: Not specified
Package contents
1 × AS46050 galvanically zinc-plated 4-hole mast clamp for Ø 48–50 mm tubes
2 × screws according to available product data
Mast tube, satellite dish, other antennas, anchors and additional installation accessories are not included unless separately specified.
AMAZON.DE – PRODUKTBESCHREIBUNG
Die AS46050 ist eine robuste 4-Loch-Mastschelle
