Hot-Dip Galvanised Pipe Clamp and Wall Mounting Plate for Ø 38–60 mm Outriggers
The AS46300 is a robust steel mounting plate designed to secure suitable round-tube outriggers and mast sections with outside diameters from Ø 38 to 60 mm.
It can be used as a component in satellite, antenna and technical wall-mounting structures, particularly with suitable S-shaped or U-shaped outriggers.
According to the available product data, the plate measures approximately 168 × 130 mm and uses two serrated clamps to grip the attached tube.
The mounting-hole centre spacing is approximately 147 × 92 mm, and the holes are intended for M8 fixings.
For tubes and outriggers Ø 38–60 mm
The clamp is suitable for:
mast tubes
S-shaped outriggers
U-shaped outriggers
suitable round-tube supports
with diameters from:
Ø 38 mm
to Ø 60 mm
Two serrated clamps
The tube is secured using:
2 serrated clamps
The serrated surfaces support grip and help resist unwanted tube rotation.
Actual holding performance depends on:
tube diameter
surface condition
wall thickness
tightening force
outrigger length
antenna weight
wind load
Hot-dip galvanised steel
The mounting plate is manufactured from hot-dip galvanised steel for suitable permanent outdoor installations.
Mounting plate dimensions
Approximate dimensions:
168 × 130 mm
Mounting-hole spacing
The centre spacing of the mounting holes is approximately:
147 × 92 mm
This is particularly important when replacing an existing wall-mount plate.
For M8 fixings
The mounting holes are intended for:
M8 screws
The required screws, anchors or plugs must be selected according to the wall structure and expected load.
Suitable for adjustable wall-bracket assemblies
When combined with an appropriate S- or U-shaped tube, the AS46300 may form part of an adjustable or pivoting wall-mount structure.
The actual adjustment range and wall offset depend on the tube geometry and complete assembly.
Approx. 37 mm dimensional value
Available product information specifies a mast/tube spacing of approximately:
37 mm
This should be treated as a dimensional product value.
The final antenna wall offset depends mainly on the attached outrigger.
Structural wall suitability
The wall or support structure must be capable of carrying the loads generated by:
antenna weight
wind area
outrigger leverage
mounting height
Special fixing solutions may be required for insulated façades or hollow masonry.
No maximum antenna size specified
No confirmed maximum satellite dish or antenna size is stated for the AS46300.
Suitability depends on the complete wall-mount assembly.
Typical applications
The AS46300 may be used for:
satellite wall brackets
S-shaped outriggers
U-shaped outriggers
repair of existing antenna wall mounts
DVB-T/T2 antenna brackets
DAB/DAB+ antennas
FM antennas
suitable radio or directional antenna systems
Technical specifications
Article reference: AS46300
Article number: 46300
EAN: 4050822463008
Product type: Pipe clamp / wall mounting plate
Material: Steel
Surface: Hot-dip galvanised
Suitable tube diameter: Ø 38–60 mm
Tube clamping: 2 serrated clamps
Plate dimensions: Approx. 168 × 130 mm
Mounting-hole centre spacing: Approx. 147 × 92 mm
Mounting holes: For M8 fixings
Spacing value: Approx. 37 mm according to product data
Maximum load: Not specified
Maximum antenna size: Not specified
Package contents
1 × AS46300 pipe clamp / wall mounting plate
2 × serrated clamps
Clamping and mounting components according to product configuration
S- or U-shaped outrigger, antenna mast, satellite dish and substrate-specific screws, anchors or plugs are not included unless separately specified.
