Ersa HR550L Hybrid Rework System 4300W mit besonders großem Platinenhalter

Ersa HR550L Hybrid Rework System
– 4300W heating power
– 2400 W bottom heater / 3 zones a 800 W / 520 x 360 mm
– 1900 W hybrid top heater 70 x 70 mm
(900W IR, 1000W hot air)
– 230V AC, single phase, 50 Hz, 16A
– 1 digital non-contact IR sensor
– Laser pointer for component ID & PCB positioning
– 2 Type K thermocouple inputs
– 1 Accu-TC sensor
– 1 thermocouple holder
– Max. PCB size 520 x 360mm
– Support rail with 2 pins
– Component clearance – 35mm at bottom – 60mm at top
– Component size 0.6 x 0.6 mm to 70 x 70 mm
(with further accessories, the smallest components up to 01005 with 0.4×0.2mm are possible)
Placement nozzle/desoldering nozzle OD Ø 5 mm
Placement nozzle/desoldering nozzle OD Ø 10 mm
Vision box with 5 MP camera for component alignment
Wide angle lens – 70x70mm and telephoto lens 25x33mm
– Two-sided LED lighting red/green
– Placement accuracy up to +/- 25 µm
– Computer-aided placement (CAP)
– Force sensor for BT placement
– Adapter for use with the Ersa Dip&Print Station
– Ethernet interface including RJ45 patch cable 2m
– Ersa HRSoft2 operating software